Instructions to operate the sound in the gym.
All user controls are in the hallway by the Boys bathroom.
To turn on the system
– Press “Power On”
To adjust the volume
Select the volume to be adjusted by pressing the button to the left of the name
Turn the knob up or down to desired level
Example – if you want to change the volume of HH 1 (wireless microphone), press the button on the controller to the left of the HH 1 to select it, then rotate the knob until you get the desired level
The levels will remain unchanged until someone changes them again
Bluetooth
In the gym – near the basketball hoop (at the parking lot end), you can connect to the sound system with a Bluetooth device.
While standing in the Above area, put your phone in “pairing mode”
Select the new device that is labeled BLUETOOTH
Once connected, you can play music on your phone into the gym sound
NOTE: if someone else is already connected, they must disconnect for a new user to connect.
NOTE: you get about a 30’ range for Bluetooth – if you walk away, it will begin losing connection
NOTE: volume can be changed at the control panel also the device volume control
iPlate
Connect a device using an adapter cable with either RCA or 3.5mm cable
National Anthem
Press the National Anthem button starts the National Anthem
Bells
Allows for volume adjustment of the bells that includes the announcements
Turn off sound
Press the “Power Off” Button
NOTES:
There are 2 available wireless mics that live in the charger on the side of the audio rack.
Please keep them in the charger when not in use
When you pickup the mic from the charger, it will turn on
Be sure the mute switch (near the top of the microphone is slid towards the handle (this mutes the microphone)
When you are ready to talk, slide the switch towards the top
Speak clearly into the mic while holding it 3” from your mouth
The Mics will last approximately 7-8 hours on a full charge
It takes approximately 3.5 hours to fully recharge